Тема: Schneider Electric Hybrid Inverter/Charger


Технические характеристики:

Electrical SpecificationsXW6048-230-50
Continuous output power6,000 W
Surge rating12,000 W
Surge current53 A rms
WaveformTrue sine wave
Peak efficiency95,4 %
Idle consumption - search mode< 7 W
AC connectionsAC1 (grid), AC2 (generator)
AC input voltage range (bypass/charge mode)156 to 280 Vac (230 V nominal)
AC input frequency range (bypass/charge mode)40 to 68 Hz (50 Hz nominal)
AC output voltage230 Vac +/- 3%
Maximum AC pass through current56 A
AC output continuous current26,1 A
AC output frequency50 Hz +/- 0,1 Hz
Total harmonic distortion< 5% at rated power
Typical transfer time8 ms
DC current at rated power131 A
Utility-interactiveDisabled (default), AC voltage range 198 to 253 Vac, AC frequency range 49,1 to 50,9 Hz
DC input voltage range44 to 64 V
Continuous charge rate100 A
Power factor corrected chargingPF (0,98)
Mechanical Specifications
MountingWall mount, backplate included
Inverter dimensions (H x W x D)580 x 410 x 230 mm (23 x 16 x 9”)
Inverter weight55.2 kg (121.7 lb)
Shipping dimensions711 x 565 x 267 mm (28 x 22.25 x 10.5”)
Shipping weight76.7 kg (169 lb)
Supported battery typesFlooded (default), Gel, AGM, custom
Battery bank size100 to 10000 Ah
Battery temperature sensor Included
Non volatile memoryYes
Display panelStatus LEDs indicate AC In status, faults/warnings, equalize mode, On/Off and equalize button battery level. Three-character display indicates output power or charge current
Multiple unit configurations Single phase: up to 3 parallel units. Three-phase: 1 unit per phase
System networkXanbusTM
Warranty5 years
Part number865-1035
Environmental specifications
Enclosure typeIP 20 (sensitive electric components sealed inside enclosure)
Operational temperature range-25 to 70 °C
Remote displayOptional XW System Control Panel monitors and configures all devices connected to XanbusTM Network
Generator supportOptional XW Automatic Generator Start module connects to XanbusTM Network. Automatically activates generator to recharge depleted battery bank or assist inverter with heavy loads
Conduit BoxOptional XW Conduit Box encloses the bottom of the inverter and protects the cabling. Provides knockouts for 3/4” (20 mm), 1” (25 mm), 1.25” (32 mm), 2.25” (60 mm), and 2.5” (65 mm) conduit
Solar Charge ControllerOptional XW Solar Charge Controller with maximum power point tracking delivers the maximum energy available from the PV array to the battery bank

Контроллер заряда Conexant MPPT 60 150


Технические характеристики:

Electrical specificationsMPPT 60 150
Nominal battery voltage12, 24, 36, 48, 60 V
Battery voltage operating range0 Vdc to 80 Vdc
Max. PV array voltage (operating)140 V
Max. PV array open circuit voltage150 V including temperature correction factor
Max. array short-circuit current60A(48A@STC)
Max. charge current60 A (for all battery voltages except 60 V)
Max. and min. wire size in conduit#6 AWG to #14 AWG (10 to 2.5 mm2)
Max. output power3500 W
Charger regulation methodThree-stage (bulk, absorption, float) plus manual equalization Two-stage (bulk, absorption) plus manual equalization
Supported battery typesFlooded, GEL, AGM, Custom
Max. power conversion efficiency93% (nominal 12 V), 96% (nominal 24 V), 97% (nominal 36 V), 98% (nominal 48 V), 99% (nominal 60 V)
General specifications
Power consumption, night time2.5 W
Battery temperature sensorIncluded
Auxiliary output5-13V, up to 200 mA
Enclosure materialIndoor, ventilated, sheet metal chassis with 2.2 cm and 2.8 cm (7/8 in and 1 in) knockouts and aluminium heat-sink
IP degree of protectionIP20
Product weight4.8 kg (10.8 lb)
Shipping weight8.0 kg (17.6 lb)
Product dimensions (H x W x D)36.8x14.6x13.8cm(14.5×5.8×5.5in)
Shipping dimensions (H x W x D)48.3x22.9x35cm(19.0×9.0×9.8in)
Device mountingVertical wall mount
Ambient air temperature for operation-20°C to 45°C (-4°F to 113°F)
Storage temperature range-40°C to 85°C (-40°F to 185°F) full power, power derating above 45°C
Operating altitudeSea level to 2000 m (6562 ft)
System network and remote monitoringAvailable
WarrantyFive-year standard
Part number865-1030-1
Display typeLCD, 2 lines 16 digits
Regulatory approval
SafetyCSA Certified (UL1741, CSA 107.1) and CE Marked for the Low Voltage Directive (EN50178)
EMCFCC and Industry Canada (Class B), CE Marked for the EMC Directive (EN61000-6-1, -6-3), C-Tick compliant

Системная контрольная панель XW System Control Panel


Технические характеристики:

Electrical SpecificationsXW System Control Panel
DisplayDot matrix 128 x 64 LCD with white LED backlight
Mechanical Specifications
Dimensions (H x W x D)6 x 4 x 1 9/16” (152 x 103 x 40 mm)
Weight0.46 lb (207 kg)
MountingFlush or surface mount, hardware included
Shipping weight1.72 lb (0.78 kg)
Dimensions (shipping)10.5 x 8.5 x 2.5” (267 x 216 x 64 mm)
Standard warrantyFive years
Part number865-1050
Environmental Specifications
Operating temperature range (full power)-4 to 122°F (-20 to 50°C)
Storage temperature-40 to 185°F (-40 to 85 °C)
Regulatory Compliance
SafetyCSA certified to CSA 107.1-01 and UL 458 including Marine Supplement
EMCFCC Part 15B Class B
Industry Canada ICES-0003 Class B
Optional Accessories
Network cables:
3 feet (0.9 m)809-0935
5 feet (1.5 m)809-0936
7 feet (2.0 m)809-0937
10 feet (3.0 m)809-0938
14 feet (4.3 m)809-0939
25 feet (7.6 m)809-0940
50 feet (15.2 m)809-0941
75 feet (22.9 m)809-0942
Network terminators:Male (two per pack): 809-0901
Female (two per pack): 809-0905